Filter
Top Products
90 Using the LDAP Configuration Interface September 2005
LDAP Command Examples
This section explains how to use the LDAP commands ldapdelete,
ldapmodify, and ldapsearch to configure the server. Each example
describes the LDAP command line options in detail.
Note that a space must appear between each LDAP command option (for
example,
-p) and its value (for example, 354). Command syntax is case sensitive.
Searching for Records
You can use the ldapsearch command to dump information out of the LDAP
tree. The following
ldapsearch command dumps out information about all
RADIUS clients.
ldapsearch -V 2 -p 354 -D "cn=oper,o=radius"
-w radadmin -s sub -T -b "radiusclass=Client,o=radius"
radiusname=*
Table 17. Searching for Records Using the ldapsearch Command
ldapsearch Option Meaning
-V 2 LDAP Version 2 is used to communicate with the
server.
NOTE: This option is not required, but
specifying it improves the performance of the
transaction.
-p 354 TCP port 354 is used to communicate with the LDAP
interface of the server.
NOTE: This option is not required, but
specifying it improves the performance of the
transaction.
-D "cn=oper,o=radius" The command is authenticated using an
administrative account called oper.
NOTE: Any administrative account name may
be used in place of oper in this example.
o=radius may not be changed.
-w radadmin The command is providing an authentication
password of radadmin.
NOTE: The -w parameter value (in this case,
radadmin) must match the passcode or cached
password of the account named by the -D
parameter.