Filter
Top Products
RSA RADIUS Server 6.1 Administrator’s Guide Using the LDAP Configuration Interface 97
Rate Statistics
Rate statistics are derived from other statistics by taking time into consideration.
Three types of rate values are calculated for each of these counter statistics:
X Current rate statistics identify the rate measured over the most recent rate
interval. The seconds-per-interval value identifies the number of seconds in
the interval over which the rate statistics are gathered.
X Average rate statistics identify the rate measured since startup, or the most
recent statistics reset command.
X Peak rate statistics identify the highest rate observed since startup, or the
most recent statistics reset command.
To read rate statistics from the LCI, you must set
stattype: rate. This results
in output such as the following:
rate-statistics-seconds-per-interval: 1
auth-request-current-rate: 0
auth-request-average-rate: 0
auth-request-peak-rate: 7
auth-accept-current-rate: 0
auth-accept-average-rate: 0
auth-accept-peak-rate: 1
auth-reject-current-rate: 0
auth-reject-average-rate: 0
auth-reject-peak-rate: 0
acct-start-current-rate: 0
acct-start-average-rate: 0
acct-start-peak-rate: 0
acct-stop-current-rate: 0
acct-stop-average-rate: 0
acct-stop-peak-rate: 0