Filter
Top Products
Table Of Contents
Note:
Changes to the IP Address take effect immediately upon being saved. Telnet connections
in place at the time of an address change will be lost.
Subnet
This parameter specifies the subnet mask of the switch.
Gateway
This parameter specifies the gateway IP address. This is the address to use when
forwarding packets to a network other than the one the switch belongs to. It is
only required if you intend to manage the switch from a management station that
is separated from the switch by a router.
Inactivity Timeout
This parameter specifies the amount of time after keystrokes have been pressed
before a management connection will be automatically broken. A value of zero
disables timeouts altogether.
Telnet Sessions
This parameter limits the number of Telnet sessions. A value of zero prevents any
Telnet access.
Note:
If you disable Inactivity Timeouts
and
reduce the number of Telnet sessions to one, you
will not be able to connect via Telnet until your current connection closes.
TFTP Server
This parameter controls how a TFTP client can access the switches built-in TFTP
server. A setting of “Disabled” prevents all access, “Get Only” allows retrieval of
files and “Enabled” allows storing and retrieval of files.
SNMP Get Community
This string determines the community string that may be used by any management
station for SNMP read-only access of settings. Delete this string if you wish to
prevent read-only access.
RuggedCom
5