Filter
Top Products
Installation
Runco CL-810 Series Owner’s Operating Manual 31
PRE
L
IMINAR
Y
Connecting 12-Volt
Trigger Output to External
Theater Equipment
If your CL-810 is equipped with a CineWide with AutoScope system, use the cable
supplied with the AutoScope Lens Motor to connect the motor to the 12-volt trigger
output as shown in
Figure 3-15.
Figure 3-15. Connecting the 12-Volt Trigger Output to the AutoScope Lens Motor
If your home theater contains a retractable screen, screen mask or other 12-volt
trigger-activated equipment, use the cable supplied with the CL-810 to connect it to the
12-volt trigger output as shown in
Figure 3-16.
Figure 3-16. Connecting the 12-Volt Trigger Output to Other Equipment
AutoScope
Lens Motor (Rear)
AC Input
Power
Switch
S-VID /
S-VID
3.5-mm
mini plug
S-VID /
S-VID
to other,
12-volt
trigger-activated equipment
(screen, screen mask etc.)
Red = +12V (Tip)
Black = Ground (Sleeve)
3.5-mm
mini plug