Filter
Top Products
Installation
26 Runco LS-HB Installation/Operation Manual
PRE
L
IMINAR
Y
Installing the Fixed
Anamorphic Lens Base
Plate
To install the base plate on an LS-HB with a fixed anamorphic lens:
1. Place the projector upside down on a blanket or other soft surface.
2. Secure the base plate and Ceiling Mount Plate (if used) to the projector with the four,
M4 x 0.7 x 14mm screws provided with the anamorphic lens base plate.
Figure 3-6. Projector with Fixed Anamorphic Lens Base Plate - Bottom View
➤
1. Do not use the mounting screws provided with the ceiling
mounting kit. Use only the hardware provided with the
anamorphic lens base plate.
2. DO NOT OVER-TIGHTEN THE SCREWS.
Caution
Ceiling Mount Plate
(part of Ceiling Mount Kit)
Anamorphic
Lens Base Plate
Screw,
Phillips
Pan-Head,
M4 x 0.7 x
14mm (4x)
1
2