Filter
Top Products
Installation
Runco LS-HB Installation/Operation Manual 41
PRE
L
IMINAR
Y
1. Use the Height/Pitch Adjustment Screws (3) and Washers (2) to attach the Lens
Mounting Bracket (5) to the Anamorphic Lens (1).
2. Remove the nut and rubber collar from each Swell Latch Assembly (4).
3. Secure the lens (with the mounting bracket attached) to the Lens Base Plate (6) using
the swell latches.
Adjusting the Lens Height and Angle:
1. Project a white field on the screen.
2. Loosen the four Height/Pitch Adjustment Screws just enough to allow vertical
movement of the lens assembly.
3. Slowly move the anamorphic lens into place so that there are no shadows on the top
or bottom of the screen:
To avoid clipping the corners of the image, position the anamorphic
lens as close as possible to the primary lens.
Tip
Too High
Too Low
Correct position