Filter
Top Products
2 - Connecting the SAGEM F@st™ 1000
User Guide - N56815740110
Page 2-6
No reproduction or communication without the written consent of SAGEM SA
Configuration with distributed microfilters
SAGEM F@st
TM
1000
Microfilter
FAX
TELEPHONE
Analog
Signal
ADSL Line
TELEPHONE
Analog
Signal
Microfilter Microfilter
The configuration with microfilters requires one microfilter for each analog terminal.
The maximum number of analog terminals that can be connected will be specified by your
Operator.
2.2.4 Connection to the wide area network (ADSL line)
Caution: Use only the "ADSL" line cable supplied with the SAGEM F@st™ 1000 for the link to
the wide area network.
This 3 m cable is terminated at both ends by an RJ11 connector (for details, refer to the
appendices).
Connect imperatively in the following order:
! Connect one of the RJ11 connectors to the corresponding connector (marked LINE) on the
rear panel of the SAGEM F@st™ 1100.
! Connect the second RJ11 connector to a corresponding connector for the link to the wide
area network.
If using a splitter or microfilters, their output must also be fitted with an RJ11 connector.
Otherwise, contact your Operator to obtain a special adapter or cable.