Filter
Top Products
1. Connect the antenna or the cable box to the TV tuner box (not included) using the "ANTENNA" terminal on
the tuner box.
2. Remove the TV Tuner Box cover from the rear of the monitor.
3. Insert the connected tuner box into the slot and firmly tighten the two screws using a coin to lock the box in
place. (Loose screws may cause a blank screen or picture noise)
4. Replace the TV Tuner Box cover.
5. Turn on the monitor.
6. Select TV using Source button among the external signal adjustment buttons.
7. Select a desired TV channel.
As this product is designed for PAL or SECAM signals only, you cannot view TV programs in countries
where NTSC signals are used.
3. Connecting to a Macintosh
1. Connect the power cord to the DC adapter and then connect the adapter jack to the DC12V power port on
the monitor. (Voltage is automatically adjusted by the power adaptor.)
2. Connect the signal cable to the D-SUB port on the Macintosh computer.
3. For older model Macintoshes, you need to adjust the resolution control DIP switch on the Macintosh adapter
(optional) referring to the switch configuration table shown on its rear.
4. Turn on the monitor and Macintosh.
Contact a local Samsung Electronics service center to buy optional items.