Sanyo PLV-Z4 Projector User Manual


 
31
Image Adjustment
To store the adjusted data, select Store and press the Point 8 or
OK buttons. The Image Level Menu will appear. Choose one of
the four (4) image levels with the Point
ed buttons and press the
OK or Point
8 buttons. The confirmation box will appear. Select
[Yes] and then press the OK or Point
8 buttons. To exit the Image
Level Menu, press the OK or Point
8 buttons at the Quit icon.
The stored data can be called up by selecting “User image 1 ~ 4”
in the Image Level Selection on page 27.
Store
To reset the adjusted data, select Reset and press the Point 8 or
OK buttons. The confirmation box will appear. Select [Yes] and
then press the OK or Point
8 buttons. All adjustments return to
their previous figures. You can also reset the adjusted data with
the RESET button on the remote control.
Reset
Choose one of the four (4)
image levels with the Point
ed buttons and press the
OK or Point
8 buttons. The
confirmation box will appear.
Select [Yes] and then press
the OK or Point 8 buttons.
Press the Point
8 or OK
buttons at this icon to
store the adjusted data.
The Image Level Menu will
appear.
COLOR SELECTION
Press the OK button when selecting COLOR M. in the Color
management list. The Color management list disappears
and the Color management pointer will appear.
Use the Point ed 7 8 buttons to move the pointer to a spot
where you want to adjust the color and then press the OK
button. The image being projected freezes and the COLOR
SELECTION window will appear. (Certain colors may not be
adjusted and in such cases, an exclamation mark will be
displayed.)
Select COLOR LEVEL, COLOR PHASE or GAMMA with the
Point
ed buttons and use the Point 7 8 buttons to adjust
them. While adjusting, the changes are reflected in the
projected image accordingly. If you press the MENU button
while operating the color selection, the Color management
pointer will be reset. After adjusting, press the OK button to
go to the Color management list.
COLOR SELECTION
Color management pointer
Use the Point ed 7 8 buttons to move
the pointer to a spot where you want to
adjust the color and then press the OK
button. The COLOR SELECTION
window will appear.
Note:
If you turn off the POWER without storing adjusted settings, all the adjusted settings
will be reset.
When resetting, the adjusted data in Advanced menu will be reset whether or not
Advanced menu in the Setting Menu is “On”. See on page 35.
COLOR MANAGEMENT LIST (continued)
In the COLOR MANAGEMENT LIST, the adjusted color data
are check marked reflecting the changes in the projected
image. (See the previous page.)
You can also decide whether or not to apply the adjusted
color data in the list to a projected image. Clear the check
mark if you do not want to apply the adjusted color data;
select the check mark and then press the OK button. The
check mark will disappear.
If you want to readjust the color, select a color data box in
the list and press the OK button. The COLOR SELECTION
window will appear and you can readjust the color. See
above for color selection.
If you want to delete a particular color data in the list, select
the DEL box of the color data and then press the OK button.
The confirmation box will appear. Select [Yes] and then
press the OK or Point
8 buttons.
Go to the Color management list (see the previous
page).
After adjusting Color level,
Color phase and Gamma,
press the OK button.
To store the adjusted data,
exit the Color management
mode and move on to
“Store” in the Image adj.
Menu.
Quit
Press the OK or Point
8
buttons at this icon to close
the dialog box.