Filter
Top Products
46
Maintenance and Cleaning
When the life of the projection lamp of this projector draws to an
end, the LAMP REPLACE indicator emits a yellow light. If this
indicator lights yellow, replace the lamp with a new one promptly.
The time when the LAMP REPLACE indicator should light is
depending on the lamp mode.
Follow these steps to replace the lamp.
Lamp
Lamp Cover
ORDER REPLA
CEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
● Model No. of your projector : PLV-Z4
● Replacement Lamp Type No. : POA-LMP94
(Service Parts No. 610 323 5998)
For continued safety, replace the lamp with the same
type. Do not drop the lamp or touch the glass bulb! The
glass can shatter and may cause injury.
Allow the projector to cool, for at least 45 minutes
before you open the lamp cover. The inside of the
projector can become very hot.
Top Control
CAUTION
Screw
Turn off the projector and unplug the AC power cord. Allow
the projector to cool for at least 45 minutes.
Loosen the two (2) screws that secure the lamp. Lift the
lamp out of the projector by using the built in handle.
1
3
Replace the lamp with a new one and secure it with the two
(2) screws. Make sure that the lamp is set properly. Replace
the lamp cover and secure it with the screw.
4
Turn the projector over. Loosen the screw that secures the
lamp cover, and then open the lamp cover.
2
Connect the AC power cord to the projector and turn on the
projector.
6
Reset the Lamp replacement counter.
See “Lamp Replacement Counter” on the next page.
5
Lamp Replacement
Handle
Screws
CAUTION
This indicator lights yellow when
the life of the projection lamp
draws to an end.