Filter
Top Products
36
HDMI setup
Select L1 or L2 with the Point 8 or OK buttons according to the
output signal of video equipment.
L1 . . . . . When the output of video equipment is set
“STANDARD”.
L2 . . . . . When the output of video equipment is set
“ENHANCED”.
The names for the output setting of video equipment vary from
equipment to equipment. For details, refer to the owner’s manual
of video equipment.
Setting
Mounting
This function is used to select the installation methods of the
projector. Press the Point
8 or OK buttons to switch between
each mode.
Off . . . . . Cancel the selected installation method.
Ceiling . . Project the image from the ceiling-mounted
projector. The picture is top/bottom and left/right
reversed.
Wall . . . . Project the image from a wall-hanging projector. The
picture is top/bottom reversed.
Rear
When this function is “On,” the picture is left/right reversed. This
function is used to project the image to a rear projection screen.
Press the Point
8 or OK buttons to switch On/Off.
Wall
Off (Normal)
Blue back
When this function is “On”, the projector produces a blue image
while an input signal is not detected. Press the Point
8 or OK
buttons to switch On/Off.
Display
This function decides whether to display the On-Screen Displays.
Press the Point
8 or OK buttons to switch between each mode.
On . . . . . . . . . . . . Show all the On-Screen Displays. Use this
function when you want to project images
after the lamp becomes bright enough. The
factory default setting is this mode.
Countdown Off . . Show the input image instead of the
countdown when turning on the projector.
Use this function when you want to project
the image as early as possible even when
the lamp is not bright enough.
Off . . . . . . . . . . . . Hide the On-Screen Displays except;
● On-Screen Menu
● “Power off?”
● “No signal” for Power management (p.37)
● “Please wait ...”
● Color management operation screen
● Panning dialog box when Normal through
is selected in the Screen Menu (p.34).
HDMI setup
Press the Point 8 or OK
buttons to select L1 or L2
according to the output
signal of video equipment.
Rear (On)
Ceiling