Sanyo SRT-2400DC Personal Computer User Manual


 
SETTING THE CASSETTE EJECT MODE
Cassette Eject Setup
When using 2 VCRs or more, the cassette tape of all the
VCRs or some of the VCRs can be ejected, if the EJECT
terminals on the VCRs are connected as indicated.
1
Press the MENU button until the (SET UP 4) menu is
displayed.
@@@@@@@<SET@UP@4>
*SW@OUT
@@TIMING@@@@@@@@@FIELD
@@FIELD@@@@@@@@@@01
@@8H@@@@@@@@@@@@@Y
*THREAD@CHECK@@@@Y
*VIDEO@LOSS@@@@@@N
*REC@SPEED@@@@@@@N
*EJECT@SET
@@EJECT@MODE@@@@@EJECT1
@@OPERATION@@@@@@SLAVE
2
Press the ] button, until the EJECT MODE setting
is flashing.
3 Press the l (or j) button to set the desired cassette
eject mode.
EJECT1 . . . . . The cassette is ejected only if the
VCR is not in recording mode.
EJECT2 . . . . . The cassette is ejected only if the
VCR is in stop mode.
4 Press the ] button, until the OPERATION setting is
flashing.
5
Press the l (or j) button to set the desired operation.
SLAVE . . . . . . When the EJECT button is
pressed, the cassette tape of that
VCR only will be ejected.
MASTER . . . . When the EJECT button is
pressed, the cassette tape of that
VCR and of any VCR connected
after it will be ejected.
6
Press the PAUSE/SEARCH button to save the
settings.
NOTE:
The EJECT button will not be operative during
recording mode.
EJECT terminal connection
EJECT IN terminal
Depending on the (SET UP 4) menu EJECT
MODE” setting (see Cassette Eject Setup), the
cassette loaded in the VCR is ejected when there is
an input at this terminal.
EJECT OUT terminal
When the EJECT button is pressed (if the VCR is
setup as MASTER, see step 5 under “Cassette
Eject Setup) or when there is an input (trigger) at
the EJECT IN terminal, a signal is output at this
terminal, even if the security lock is set or if a
cassette is not loaded.
VCR No. 1
EJECT
OUT IN
VCR No. 2
EJECT
OUT IN
COM
COM
NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001
English
37