Filter
Top Products
Alarm Settings
9
ALARM SOUND MODE
This setting causes an alarm warning to sound
when an alarm is detected. If set to “USE”,
“BEEP OFF” appears in the initial screen when
an alarm is detected at the same time as the
alarm buzzer sounds. If you click this indicator,
the alarm buzzer will stop.
F
ALARM BUFFERING
Set to “ON” to record alarm recording images
into the camera’s internal memory, and then
click the [DETAIL] button. The ALARM
BUFFERING SET screen will be displayed so
that you can make detailed settings.
G
RECORD SIZE
If “FULL” is selected, data is recorded
continuously until the selected record size (such
as 16 or 12MB) is reached. Furthermore the
“CC” setting allows data to be recorded in the
internal memory up to the specified size but only
while the external alarm is being detected (while
an external alarm signal is being input).
Available settings:
FULL, CC (can only be set when MOTION
DETECTOR is set to “OFF”)
ALARM BUFFERING SET Setting
If you click the [DETAIL] button next to “ALARM
BUFFERING”, the ALARM BUFFERING SET
screen will be displayed. This screen is used to
set the way in which the alarm data that is
generated when an alarm is detected is
recorded into the camera’s internal memory. The
recording capacity of the internal memory is set
to a default of approximately 16 MB per alarm
event.
1
ALARM DATA SIZE
This sets the size for alarm data that is recorded
into the internal memory. The pre/post selection
ratio for the alarm recording area will vary
depending on the size that is set.
Available settings:
•
16, 12, 8, 4 MB: All available alarm recording
area ratios can be selected.
•
2 MB: The pre/post ratio of 1/9 cannot be
selected.
•
1 MB: The pre/post ratios of 1/9 and 2/8
cannot be selected.
•
0.5 MB, TWO IMAGES: The pre/post ratio is
fixed at 0/10.
Note: “TWO IMAGES” can be selected when
PPP is being used.
2
BUFFERING AREA
This sets the ratio between the pre-alarm and
post-alarm recording areas in the internal
memory.
Available settings:
(PRE/POST) 0/10, 1/9, 2/8, 3/7, 4/6, 5/5
3
BUFFERING RATE
This sets the recording rate (buffering rate) when
data is being recorded into the internal memory.
Available settings:
MAX, 10FPS, 5FPS, 2FPS, 1FPS
4
PRIORITY
This sets the quality for the images recorded in
the internal memory.
•
PICTURE QUALITY: Alarm images are
recorded at high image quality.
•
TIME: Images are recorded with speed as
the priority.
When this setting is made, the time taken for
recording alarm data is reduced.
1
2
3
4
5
6
L5AM2/US (VCC-WB4000) GB 2003, 6, 6
– 34 –
English