Filter
Top Products
Alarm Settings
5
ALARM RESOLUTION
This sets the image size for data being recorded
into the internal memory.
Note: When playing back images that have
been recorded at a size of 720x240, the
vertical size will be adjusted so that they
become 720x480 images.
6
OVERWRITE
Always be sure to insert the expansion memory
card into the card slot before turning on the
power for the camera. If you insert the card after
the power has been turned on, this item will not
be displayed.
If this is set to “ON”, old alarm images are
automatically deleted when the internal memory
becomes full, and the new data is written over as
it is captured.
External Alarm Sensor Setting
1
Connect a device such as an infrared
sensor to the ALARM IN terminal at the
rear of the camera.
2
Set “ALARM REC USE” to “NO USE”
(example).
3
Set “EXTERNAL ALARM” to “NO”
(example).
For example, if a door is closed, it will trigger
an alarm.
For details, see “2 EXTERNAL ALARM”.
4
Set “ALARM OUT” to “NO” (example).
For example, you can cause a buzzer that is
connected to the ALARM OUT terminal to
sound.
For details, see “6 ALARM OUT”.
5
Set “ALARM OUT MODE” to “ALARM
OUT”.
6
Use the drop-down list box to change the
“ALARM OUT TIME” setting to “60 sec.”
(example).
7
Set “ALARM SOUND MODE” to “USE”.
8
Set “RECORD SIZE” to “CC”.
If “CC” is selected, recording will only be
carried out while an alarm is being input. If
“FULL” is selected, recording will continue
from the point where an alarm starts to be
input until the recording area is full. The
recording area is the capacity that has been
set in “BUFFERING AREA”.
9
Set “ALARM BUFFERING” to “ON”, and
then click the [DETAIL] button.
The ALARM BUFFERING SET screen will be
displayed.
10
Change any settings that are required
for recording alarm images into the
internal memory, and then click the
[SET] button.
For example, you can set the following.
The alarm images (16MB) will be recorded
at high quality at a resolution of 720x240.
11
Set “ALARM REC USE” to “USE” and
then click the [SET] button.
When an alarm is detected, the alarm will
sound and the ALARM DATA indicator in
the initial screen will be displayed.
2
3
4
5
6
7
9
8
L5AM2/US (VCC-WB4000) GB 2003, 6, 6
English
– 35 –