Filter
Top Products
Section 3: Configuration and Operation
Page 3-12 LM Basic 408e/412e Operator’s Manual
3.6 SERVICE MODE
3.6.1 Service
In this mode, pressing the LINE button brings you to the
COUNTERS mode screen. Otherwise, press FEED to proceed to
adjust service mode settings.
In the following screens of Service Mode, you can control the Slice Level, Auto Line Feed, Feed
On Error, Reprint W/Feed, Forward/Backfeed Amount, Forward/Backfeed Distance, Euro Code
symbol, Menu Language, Command/LCD Priority. Ignore CAN/DLE, Ribbon Near End detection,
IEEE1284 ACK width, and Backfeed Speed.
3.6.2 Slice Level
For the Gap and I-Mark sensors, this setting lets you set the slice
level to control the gap detection for label stopping. The upper
value shows the current sensor detection level, and the lower value
is for adjustment. If the value is set at 0.0V, the printer will automatically set the slice level.
Use the LINE button to set the slice level from 0.0 to 3.2V. Use the
FEED button to select the input value and proceed to the next
setting screen.
3.6.3 Auto Line Feed
Use this function to determine whether the printer automatically
feeds a label upon being turned ON/going online. Select YES for an
auto line feed; otherwise select NO. The default setting is NO.
Press the LINE button to select YES or NO, then press the FEED button for the next screen.
3.6.4 Feed On Error
Use this function to determine whether the printer automatically
feeds a label upon resuming from an error condition. Select YES for
an auto line feed; otherwise select NO. The default setting is NO.
Press the LINE button to select YES or NO, then press the FEED button for the next screen.
3.6.5 Reprint W/Feed
Determines if the FEED button generates a reprint of the most
recently printed label during ONLINE mode. Default is NO.
Press the LINE button to select YES or NO, then press the FEED
button for the next screen.
SERVICE MODE
GAP [X. XV]
INPUT [X. XV]
EYE [X. XV]
INPUT [X. XV]
AUTO ONLINE FEED
YES NO
FEED ON ERROR
YES NO
REPRINT W/FEED
YES NO