Section 3: Configuration and Operation
LM Basic 408e/412e Operator’s Manual Page 3-13
3.6 SERVICE MODE (CONT’D)
3.6.6 Forward/Backfeed Amount
This setting allows customization of the label feed/backfeed
distance instead of the default setting.
If DISTANCE is selected, the next menu appears, for setting of the
amount of label feed/backfeed. Use the LINE button to select
DISTANCE or DEFAULT, and if applicable, to set the amount of
label feed/backfeed.
Press the
FEED
button for the next screen.
3.6.7 Euro Code
This setting defines the code to represent the Euro mark. The
default is D5H.
Use the FEED button to move the cursor to the set the value of the
code. Use the LINE button to set the value under the cursor. When the value has been set, the
following screen appears.
3.6.8 Select Language
This screen lets you choose the language used for all commands
and messages on the LCD. Use the LINE button from ENGLISH
(default), FRENCH, GERMAN, SPANISH, ITALIAN,
PORTUGUESE and two repeated options for ENGLISH. Press the
FEED button to confirm the setting and proceed to the next screen.
3.6.9 Command or LCD Priority
Use this setting to determine whether SBPL commands are
accepted and allowed priority over settings of Print Darkness, Print
Speed, Print Offset via LCD. The default setting is COMMAND,
where SBPL commands take precedence over settings made via
the LCD menus.
Press the LINE button to select Command or LCD. Press the FEED button for the next screen.
3.6.10 Ignore CAN/DLE
Determines whether the CANCEL and DATA LINK ESCAPE codes
are processed or ignored. Select YES to ignore, and NO to process
the codes. The default is NO.
Press the LINE button to select YES or NO, then press the FEED button for the next screen.
FORWARD/BACKFEED
DISTANCE DEFAULT
FORWARD/BACKFEED
DISTANCE 001MM
EURO CODE
D5
SELECT LANGUAGE
ENGLISH
PRIORITY SETTING
COMMAND LCD
IGNORE CAN/DLE
YES NO