Filter
Top Products
Special Notes 1. A reverse image area is affected by the rotate commands.
Therefore, always assume the printer is in the normal print
orientation when designing and sending the Reverse Image
command.
2. If using reverse images with the form overlay, place this command
before the Form Overlay command in the data stream.
3. If the Rotate commands are used with this command, the V and H
parameters are reversed.
4. If the height and width to be reversed contain other than
alphanumeric data, the area is not printed.
5. If the values specified exceed the maximum ranges, the reverse
image is not created.
6. The maximum allowable settings are as follows:
CT400 CL412
Horizontal
aaaa
0001 to 0832 0001 to 1248
Vertical
bbbb
0001 to 3200 0001 to 4800
Section 4. Programming Reference
Page 4-669001069A SATOCTSeriesPrinters