SATO CT410 Printer User Manual


 
CONFIGURATION PANEL
The Configuration Panel can be accessed by opening the Top Cover. It consists of an
eight position DIP switch, three adjustment potentiometers and a seven segment LED
Error display. Receptacles for connecting the Dispenser and Cutter options are also
located on this panel.
CONFIGURATION SWITCH
An eight position DIP switch is utilized for setting the operating conditions of the
printer.
Paper Handling (DSW1-3). Selects the method used for controlling the paper
handling.
Continuous - Does not use the sensor for paper indexing. The paper
movement will stop after all the label data has been printed.
Tear Off - Paper is fed out to the cut/tear off position after printing is
complete. Before the next label is printed, the paper is pulled back in to the
first print line position.
Cutter Mode - Enables the Cutter option if installed.
Dispenser Mode - Enables the Label Taken sensor if the Dispenser option is
installed.
Paper Handling
Head Check
Print Mode
VR1 Adjust
Hex Dump
I/F Select
VR1
Potentiometer
Configuration
Switch
Error
Display
DSW1 DSW2 DSW3 SETTING
Off Off Off Continuous
On Off Off Tear Off
Off On Off Cutter Mode
On On Off Dispenser
12345678
ON
OFF
Configuration Switch
Section 2. Installation and Configuration
SATOCT SeriesPrinters9001069A Page2-13