Filter
Top Products
come off the top of the roll. The
Paper Guides will automatically
position the Roll Holders to
suspend the roll.
7. Route the label material through the
Paper Sensor Assembly and
over the Platen. Note that the
Sensor is part of the left Label
Roll Guide so that the Paper
Sensor is always positioned in the
same location relative to the left
edge of the label.
8. Close and latch the Print Head Assembly.
9. Press the LINE key so that the printer is in the OFF LINE mode and then
press the FEED key. The label should advance to the next index (label
gap or eye-mark) position.
Fanfold Media
1. Place the fanfold media behind the
printer with the printing surface
up.
2. Open the Top Cover by by pressing
on cover release points located on
each side of the printer. This
releases the cover latch and allows
it to swing upward on the rear
mounted hinge points.
3. Carefully break out the Fanfold
Access Panel from the back of
the Top Cover.
4. Release the Print Head Assembly
by pressing the Head Latch to
the rear. This allows the assembly
to rotate upward to the left
allowing easy access for ribbon
routing. Rotate the assembly until
it is vertical.
5. With the Print Head Assembly in the up position, press the Paper Guide
Release while adjusting the Paper Guides until they allow a media to fit
between them. A millimeter scale is molded into the case to provide a
guide when making the adjustment. The Paper Guides are center
justified and interact with each other so that each moves an equal distance.
6. Route the label material through the Sensor Assembly and over the
Platen.
Paper Sensor
Platen
Break Out for
Fanfold Paper
Section 2. Installation and Configuration
Page 2-89001069A SATOCTSeriesPrinters