Filter
Top Products
13
Table
4. Printed Overstrike Error Messa
g
es
Error Messa
g
e
Ex
p
lanation
T
ag R/W Err
x
Check media
Tag Comm
Err
x
Check cable
The printer software attempted to write to or read from the
RFID tag, but the RFID encoder indicated that the tag could
not be written to, or read from.
The printer software temporarily lost communication with the
RFID encoder, or communication between the printer
software and the RFID encoder was not synchronized and
had
t
o be fo
r
ced.
NOTE:
The x in the error messages represents a number code that identifies the area
in the printer software or RFID encoder where the failure occurred.
Custom Setting
This menu item contains submenus that allow the RFID encoder to work with tag types that are not
listed in the Tag Type menu item.
NOTE: SATO cannot guarantee the performance of tag types not certified by SATO.
Custom Setting Submenus
Custom Tag
This menu item enables or disables the Custom Setting submenus. The default is Disable.
When Custom Tag is set to Disable, the settings in the Custom Setting submenus are ignored by
the RFID encoder.
When it is set to Enable, the RFID encoder uses the settings in the Custom Setting submenus,
which must be set to match the characteristics of the custom tag.
When it is set to Duplicate, the settings of the selected Tag Type menu item are copied into the
Custom Setting submenus, but are ignored by the RFID encoder.
I
n
t
ro
d
uc
ti
on
t
o
th
e
RFID
con
fi
gura
ti
on op
ti
ons