Filter
Top Products
Powering Off the Machine
73
7
Powering Off the Machine
Peripheral devices such as the HDD
and memory are used by a variety of
functions. Correct power-off proce-
dures must be observed in order to
avoid damaging these peripherals.
Also, remember that powering off the
machine may result in loss of any
scan data that is awaiting transmis-
sion.
This section explains procedures and
precautions to be observed when
turning off the machine's main pow-
er.
Reference
For more information, see "Turn-
ing On and Off the Power" in the
System Settings manual.
Turning Off the Operation
Switch
A
Make sure that the exposure glass
cover or ADF are closed.
B
Press the Operation Switch and
check that the power indicator
goes off.
Note
❒ Under the following conditions,
pressing the Operation Switch
causes the power indicator to
flash instead of going out.
• The exposure glass cover or
ADF is open.
• Communication is taking
place between the machine
and a connected device.
• The HDD is operating.
Turning Off the Main Power
Switch
Preparation
Normally do not turn off the main
power. If you turn off the main
power, see the Important below in
advance.
Important
❒ Do not turn off the main power
switch if the power indicator is lit
or flashing. Damage to the HDD or
memory may result.
❒ Unplug the machine before turn-
ing off the main power switch.
Damage to the HDD or memory
may result.
❒ Before turning off the main power
switch or unplugging the machine,
check the memory remaining is
100%. After about 1 hour passes af-
ter the main power switch is
turned off or the machine is un-
plugged, undelivered documents
contained in fax memory will be
lost. ⇒"When Power is Turned Off
or Fails" in the Facsimile Reference
Advanced Features