Filter
Top Products
Setup Steps for Administrators
BlackArmor® NAS 110 User Guide 18
Setup Steps for Administrators
If you are not a BlackArmor administrator, skip to page 26.
Installing the BlackArmor NAS 110 Server and Software
Before you begin:
• Ensure that your computer meets the requirements listed on page 8.
• Ensure that you have a solid, flat, stable surface for the server to sit on in an area with
reliable ventilation. Ensure that the server’s vents will not be covered or blocked and that
the server is not placed near a heat source. Ensure that the server won’t be in an area
where liquids may be spilled on it.
To install the BlackArmor NAS 110 server and software:
1. Use the Ethernet cable included in the kit to connect the BlackArmor NAS 110 server to a
switch or router on your local network. Connect the Ethernet cable to the Ethernet port on
the back of the server, as shown below.
2. Use the power adapter included in the kit to connect the BlackArmor NAS 110 server to a
grounded power outlet.
Figure 4: Connect power and network cables
Step 1
Step 2