Filter
Top Products
23
COPY FUNCTIONS
2
Auto paper select mode (Two-tray model only)
When the AUTO PAPER SELECT indicator ( ) lights up, "Auto paper select mode" is enabled. This function
automatically selects the paper that is the same size as the original A5, A4, A4R, B4, A3 paper. "Auto paper select
mode" can be disabled in the user programs. (p.38)
• The sizes of paper that can be loaded vary by country and region.
• If a zoom setting is selected after placing the original, the paper size that is appropriate for the zoom setting will
be automatically selected.
• "Auto paper select mode" is cancelled if the automatic ratio selection is enabled (p.25) or if a tray is selected
with the [TRAY SELECT] key ( ). Auto paper select resumes operation when the [CLEAR ALL] key ( ) is
pressed or when "Auto clear time" activates.
Removing the document cover
To copy large originals like newspapers, remove the
document cover. To remove the cover, lift straight
up as shown. To replace the cover, do the reverse.
The SPF cannot be removed.
Copying books or originals with folds or
creases
Press down on the document cover/SPF while
copying as shown. If the document cover/SPF is not
completely closed, shadows may appear on the
copy or it may be fuzzy. Straighten originals with
folds or creases well before placing.
Originals that can be used in the SPF
Originals that are A5 to A3 and 56 g/m
2
to 90 g/m
2
can be used. A maximum of 40 pages can be
placed at once.
For originals that are B4 or larger (A3), a maximum
of 30 pages can be placed at once.
Originals that cannot be used in the SPF
The following originals cannot be used. These may
cause misfeeds or smudging and unclear images.
• Transparencies, tracing paper, other transparent or
translucent paper, and photographs.
• Carbon paper, thermal paper.
• Originals that are creased, folded, or torn.
• Glued originals, cut-out originals.
• Originals with binder holes.
• Originals printed using an ink ribbon (thermal
transfer printing), originals on thermal transfer
paper.
Stream feeding mode
If "Stream feeding mode" is enabled in the user
programs (p.38), the SPF indicator will blink for
about 5 seconds after all originals are fed. If a new
original is placed in the SPF during this time, the
original will be automatically fed in and copying will
begin.
AUTO
• Make sure that there are no paper clips or
staples on the original.
• Straighten curled originals before placing
them in the document feeder tray. Curled
originals may cause misfeeds.
Note
AL-1633_1644_EX.book 23 ページ ２００３年１０月２３日 木曜日 午後８時２１分