Filter
Top Products
53
5
INDICATORS AND DISPLAY
MESSAGES
If one of the following indicators lights up or one of the following messages appears in the display, check the
meaning of the indicator or message in the following table and take appropriate action.
Indication Cause and solution Page
TD cartridge
replacement
required indicator
Steadily
lit
Replacement of TD cartridge will be needed soon. Prepare
a new cartridge.
61
Blinking
TD cartridge must be replaced. Replace it with a new one.
Drum cartridge
replacement
required indicator
Steadily
lit
Replacement of drum cartridge will be needed soon.
Prepare a new cartridge.
62
Blinking
Drum cartridge must be replaced. Replace it with a new one.
Paper required
indicator
Steadily
lit
The tray is out of paper. Load paper. It is also possible that
the tray is not inserted completely into the machine. Make
sure it is inserted correctly.
17
Misfeed indicator Blinking
A paper misfeed has occurred. Remove the misfeed as
explained in "MISFEED REMOVAL".
54
ORIGINAL SIZE indicator Blinking
The original is not placed in the correct orientation. Rotate the
original so that it is in the same orientation as the blinking
ORIGINAL SIZE indicator.
16
PAPER SIZE indicator Blinking
A blinking paper feed location means that the size of paper
loaded in the tray is different from the paper size setting for the
tray. Change the paper size setting.
To clear the display, do one of the following:
• Use the [TRAY SELECT] key ( ) to change the tray
selection.
• Open and close the tray.
• Press the [CLEAR ALL] key ( ).
19
[CH] appears in display
Steadily
lit
The front cover or the side cover is open. Close the front
cover or the side cover.
–
Blinking
The drum cartridge or TD cartridge is not installed correctly.
Reinstall the drum cartridge or TD cartridge. If [CH] still
blinks in the display after reinstalling the drum cartridge or
TD cartridge, contact your authorised service
representative.
61
Letters and numbers appear
in the display
Turn off the power switch, wait about 10 seconds, and then
turn on the switch again. If this does not clear the message,
write down the code that appears and then unplug the
power cord and contact your authorised service
representative. Tell your authorised service representative
what code appeared and the circumstances under which it
appeared.
–
When "Use close paper size" is disabled
The PAPER SIZE indicator on the operation panel will blink.
You can press the [TRAY SELECT] key ( ) to select a tray
manually, or load paper in the bypass tray and press the
[ON LINE] key ( ) to begin printing.
Online
manual
Misfeed indicator
Paper required indicator
TD cartridge replacement
required indicator
Drum cartridge replacement required indicator
Display
A3
A4
A4
A5
B4
EXTRA
AL-1633_1644_EX.book 53 ページ ２００３年１０月２３日 木曜日 午後８時２１分