Filter
Top Products
39
USER SETTINGS
4
*
3
AL-1633 is as follows:
1: Paper tray (factory default), 5: Bypass tray
19
Offset of paper output
tray
0: OFF
1: ON
•
When enabled, this function offsets the position
in the paper output tray of interrupt copy jobs,
and print jobs when using the printer function.
23
Resolution in
Auto/Text mode
1: 300dpi
2: 600dpi
• The copy resolution in auto and text mode is
normally 300 dpi. If high-quality copies are
preferred, use this setting to change the
resolution to 600 dpi.
25 Key auto repeat
0: OFF
1: ON
• Use this setting to select whether or not
holding down a key causes repeated input of
the key. For keys that normally cause a set
value to increase when held down (for
example, holding down the [ZOOM] key (
,
)), this program can be used to have the set
value not change when the key is held down.
26 Key press time
1: Minimum
(current response
speed)
2: 0.5 sec.
3: 1.0 sec.
4: 1.5 sec.
5: 2.0 sec.
• Use this setting to select how long a key must
be pressed for the input to be accepted. By
selecting a longer time, you can prevent
settings from being changed by the accidental
pressing of a key.
27 Audible signals volume
1: Short beep
2: Long beep
3: OFF
• This sets the volume of beep signals. (p.40)
28
Base setting beep
signal
0: OFF
1: ON
• Use this to sound a beep when a base setting
is selected. (p.40)
29 Number of copies limit
1: 99 copies
2: 999 copies
• Use this setting to select 99 or 999 for the
maximum number of copies.
30 Use close paper size
0: OFF
1: ON
• When this function is enabled, printing in
printer mode will automatically continue using
a different size of paper if the specified size of
paper runs out in all trays. This feature does
not function in copy mode.
31 Default tray setting
1: Upper paper tray*
3
2: Lower paper tray*
3
5: Bypass tray*
3
• Use this program to select a default tray. This
tray is automatically selected each time the
power is turned on or each time the machine
reverts to the initial settings.
32
Default exposure
mode
1: AUTO
2: TEXT
3: PHOTO
• Use this program to set "AUTO", "TEXT", or
"PHOTO" as the default exposure mode.
Program
number
Program name
Setting codes
(factory default setting
appears in bold)
Explanation
AL-1633_1644_EX.book 39 ページ ２００３年１０月２３日 木曜日 午後８時２１分