Filter
Top Products
25
An arm or stand based on the VESA standard
(purchased separately) can be attached to the
monitor.
Procurement of the arm or stand is at the custom-
er's discretion.
Arms or stands able to be used
Attachments must satisfy the following.
- Compatible with the VESA standard
- Have a gap of at least 100 mm x 100 mm
between the screw holes on the section to be
attached
- Not be likely to fall off or break off after being
attached to the monitor.
How to attach the arm or stand
Note:
- While following these instructions, please also
refer to the installation instructions in the
operation manual included with the arm or stand
- Do not overly bend the cable or add extension
cords as this could lead to malfunction.
1. Spread out a soft cloth on a suitable horizontal
surface.
2. Being careful not to damage the monitor, gently
lay the monitor on it display-side down.
3. Remove the stand cover.
4. Remove the two screws, and remove the cover.
Instructions for attaching a VESA compliant arm
5. Remove the four screws and then remove the
stand from the monitor.
6. Attach the arm to the monitor with the four
screws.
(Rear view)
Four screws
Stand
Stand cover
Cover
Two screws
The screws used to attach the arm should be M4
screws with a length of 8 mm ~ 10 mm protruding
from the surface to be attached.
Using any other kind of screw may lead to the
monitor falling off or damage to the internal part of
the monitor
Lift one side
Screw used to attach arm
Arm
Part of monitor to which arm
is attached