Filter
Top Products
Connections and Setup
-23
Connecting to a
Computer Using a DIN-
D-sub RS-232C Adaptor
and an RS-232C Serial
Control Cable
When the RS-232C terminal on the projector
is connected to a computer with a DIN-D-sub
RS-232C adaptor and an RS-232C serial con-
trol cable (cross type, sold separately), the
computer can be used to control the projec-
tor and check the status of the projector. See
page 89 for details.
1 Connect the supplied DIN-D-
sub RS-232C adaptor to an RS-
232C serial control cable (sold
separately).
2 Use the above cables to con-
nect the projector and the com-
puter.
Note
•Do not connect or disconnect an RS-232C
serial control cable to or from the com-
puter while it is on. This may damage your
computer.
•The RS-232C function may not operate if
your computer terminal is not correctly set
up. Refer to the operation manual of the
computer for details.
•See page 88 for connection of an RS-
232C serial control cable.
Optional
cable
RS-232C serial control cable
Type: AN-C10RS (32'10" (10.0 m))
RS-232C terminal
To Audio
Output port
DIN-D-sub
RS-232C adaptor
Supplied
accessory
Desktop computer
RS-232C serial control cable
(sold separately)
DIN-D-sub
RS-232C adaptor
Controlling the Projector by a Computer