Filter
Top Products
79
Reading (X) and Resetting (Z)
of Sales Totals
• Use the reading function (X) when you need to take the reading of sales information entered
after the last resetting. You can take this reading any number of times. It does not affect the
POS terminal’s memory.
• Use the resetting function (Z) when you need to clear the POS terminal’s memory. Resetting
prints all sales information and clears the entire memory except for the GT1 through GT3, reset
count, and consecutive number.
• X1 and Z1 reports show daily sales information. You can take these reports in the X1/Z1
mode.
• X2 and Z2 reports show periodic (monthly) consolidation information. You can take these
reports in the X2/Z2 mode.
• In the OP X/Z mode, an clerk and/or cashier can take his or her report.
• If you want to stop the printing report, press the
L
key. Even if the printing is stopped, the
consecutive number (and Z counter if you are printing a Z report) is increased by one.
Please kindly take note to take Clerk reports instead of Cashier reports when “cashier only
system” is applied to your machine. Only when “clerk + cashier system” is applied, you can take
both of Clerk and Cashier reports.
■ How to take a X1/Z1 or X2/Z2 report
[To take a X1 or X2 report:]
1. Move the mode key to OP X/Z, X1/Z1, or X2/Z2 position.
2. Select “1 READING” to display the report lists.
3. Select a report title listed in the table shown later. When you select an item with parentheses on the
opening screen, you can jump to the pertinent report title(s).
4. If needed, enter corresponding values described in the “Data to be entered” column on the table
shown later.
[To take a Z1 or Z2 report:]
1. Move the mode key to OP X/Z, X1/Z1, or X2/Z2 position.
2. Select “2 RESETTING” to display the report lists.
3. Select a report title listed in the table shown later.
4. If needed, enter corresponding values described in the “Data to be entered” column on the table
shown later.
5. After the report has been taken, the message “ARE YOU SURE ?” will appear.
Select one of the following actions:
• Select “YES” to reset the sales information.
• Select “NO” to save the sales information.
■ Flash report
You can take flash reports (display only) in the X1 mode for department sales, cash in drawer (CID) and
sales total at the point you take the report
1. Move the mode key to X1/Z1 position.
2. Select “3 FLASH MODE” to display the flash report menu.
3. Select “DEPT SALES” to take a flash report of department sales, “CID” to take a flash report of cash
in drawer, or “SALES TOTAL” to take a flash report of sales total.
NOTE
X1/Z1 MODE
X2/Z2 MODE
8
OPXZ MODE