Filter
Top Products
Messages and Signals
134
Messages and Signals
Display messages
Note:
If you have turned on the Caller ID function, see Caller ID in
Chapter 8 for display messages related to Caller ID.
CHECK PAPER SIZE The paper size setting is incorrect. Change the paper
size setting as explained on page 23.
COVER OPEN The print compartment cover (under the operation
panel) is open. Open the operation panel (grasp the
top and pull toward you), and then press down firmly
on both sides of the print compartment cover to close
it.
DOCUMENT JAMMED The original document is jammed. See the following
section,
Clearing Paper Jams
.
FAX RX IN MEMORY A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
FILM END The imaging film may need replacement. Check the
film and replace if necessary.
FUNCTION MODE The
FUNCTION
key has been pressed.
HOLD The
HOLD/SEARCH
key has been pressed to put the
other party on hold during a phone conversation.
Press the
HOLD/SEARCH
again to take the other
party off hold.
LCR DOWNLOADING The fax machine has called OpenLCR and is
receiving carrier rate data. This message only
appears if you have registered with OpenLCR.
DOWNLOAD ERROR The fax machine was unable to download rate data
from OpenLCR. Try downloading the data manually
as explained in
Downloading (receiving) the rate data
manually
on page 39.
all-ux340L.book Page 134 Thursday, December 23, 1999 5:37 PM