Filter
Top Products
Messages and Signals
135
11. Trouble-
shooting
LINE ERROR Transmission or reception was not successful. Press
the
STOP
key to clear the message and then try
again. If the error persists, see
Line Error
on page
129.
LINE IS IN USE An extension phone connected to the fax is being
used. Do not lift the fax's handset or attempt
transmission at this time, as this will interrupt the
conversation on the extension phone.
MEMORY IS FULL The memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been received
to memory because printing is not possible (an
additional message will indicate the problem), resolve
the problem so that printing can continue (see
Substitute Reception to Memory
on page 79). If you
are attempting to transmit from memory, see
If the
memory becomes full
on page 110.
MEMORY PRINTING The fax is preparing to or printing out a document
from memory.
NO DATA This appears if you attempt to search for an
automatic dialing number when none have been
stored.
NO SERVICE This appears if you haven’t registered with OpenLCR
and press the
FUNCTION
key and
7
.
NO # STORED You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn’t been programmed (a full
number hasn’t been assigned to it).
OFF HOOK This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the
STOP
key to clear the message.
ON HOOK DIAL The
SPEAKER
key has been pressed and the fax
machine is waiting for you to dial.
OUT OF PAPER You are out of printing paper (or the paper release
plate is open). Load paper as explained in
Loading
Printing Paper
on page 22.
all-ux340L.book Page 135 Thursday, December 23, 1999 5:37 PM