Filter
Top Products
<P=002>
Loading the Document
Up to 20 pages can be placed in the feeder at one time. The pages will be auto-
matically fed into the fax starting from the page on the bottom.
♦ If you need to send or copy more than 20 pages, place the additional pages
gently and carefully in the feeder just before the last page is scanned. Do
not try to force them in, as this may cause double-feeding or jamming.
♦ If your document consists of several large or thick pages which must be
loaded one at a time, insert each page into the feeder as the previous page
is being scanned. Insert gently to prevent double-feeding.
1
Adjust the document guides to the width
of your document.
2
Place the document face down and push
it gently into the document feeder. The
top edge of the document should enter the
fax first.
• The feeder will draw the leading edge
of the document into the fax. READY
TO SEND will appear in the display.
3
You can now either make resolution and/or contrast settings as described in
the following section, or dial the other party as described in the section, "Di-
aling and transmission".
Important:
If you need to remove the document from the feeder before transmission or
copying, first open the operation panel by pulling the front edge up (grasp it
at the PANEL RELEASE mark), and then remove the document. If you try
to pull the document out without opening the operation panel, you may
damage the feeder mechanism.
Chapter 3 Sending Documents
33