Filter
Top Products
35
Basic
Operation
Switching the Input Mode
Select the appropriate input mode for the
connected equipment.
Press HDMI 1/2, COMPONENT or
COMPUTER on the remote control to
select the input mode.
When you select the input mode with
INPUT R/P on the projector:
When R/P is pressed, the INPUT list
appears. While the INPUT list is
displayed, follow the procedure below to
switch the input mode.
INPUT
HDMI1
HDMI2
COMPONENT
COMPUTER
INPUT list
–Press R/P to select the desired input
mode and then press ENTER.
If ENTER is not pressed, the projector
switches to the selected input mode in a
few seconds.
When you switch the input mode, the image
as shown below will be displayed in the upper
right corner of the screen. (You can confi rm
the selected input mode and information on
the input signal.)
HDMI1
YPbPr
1080P
When is displayed, “3D” is set to “On”.
If
is displayed, it means that a 3D image
signal that can be automatically detected is
being input.
•
•
•
Note
■
•
•
HDMI 1/2, COMPONENT
and COMPUTER buttons