Filter
Top Products
49
Useful
Features
Pict.
Clock
Phase
H-Pos
V-Pos
Reset
Resolution
Auto Sync On
Auto
0IRE
Signal Type
Signal Info : 1080P
H : XX.X kHz/ V : XX.X Hz
Video Setup
Auto
Dynamic Range
SEL./ADJ.
RETURN
ENTER
END
SIG-ADJ
SCR
PRJ Net.
0
0
0
0
*
* Displayed when the input mode is HDMI input.
Adjusting the Computer Image
Use the SIG-ADJ function in case of
irregularities such as vertical stripes or
fl ickering in portions of the screen.
Selectable
items
Description
Clock Adjusts vertical noise.
Phase Adjusts horizontal noise (similar to
tracking on your VCR).
H-Pos Centers the on-screen image by
moving it to the left or right.
V-Pos Centers the on-screen image by
moving it up or down.
You can automatically adjust the computer
image by setting “Auto Sync” in the “SIG-ADJ”
menu to “On”, or pressing AUTO SYNC on
the remote control.
Depending on the type of input signal, the
adjustment range for each setting may vary or
the adjustment may not be available at all.
To reset all adjustment items, select “Reset”
and press ENTER
.
•
•
•
Note
Setting the Resolution
Ordinarily, the type of input signal is detected
and the correct resolution mode is automatically
selected. However, for some signals, the optimal
resolution mode in “Resolution” in the “SIG-
ADJ” menu may need to be selected to match
the computer display mode.
Avoid displaying computer patterns which repeat
every other line (horizontal stripes). (Flickering
may occur, making the image hard to see.)
Information on the currently selected input
signal can be confi rmed in item
7 on page 50.
•
•
Note
Auto Sync (Auto Sync Adjustment)
Selectable
items
Description
On Auto Sync adjustment will occur when
the projector is turned on or when the
input signals are switched, when con-
nected to a computer.
Off Auto Sync adjustment is not
automatically performed.
Auto Sync adjustment is also performed by
pressing AUTO SYNC on the remote control.
When setting “Auto Sync” to “Off”, and if
AUTO SYNC is pressed, Auto Sync will be
executed in “On” mode. If the button is
pressed again within one minute, Auto Sync
will be executed in “On” mode.
The Auto Sync adjustment may take some
time to complete, depending on the image of
the computer connected to the projector.
When the optimum image cannot be achieved
with Auto Sync adjustment, use manual
adjustments.
•
•
•
•
Note
Computer Image Adjustment (“SIG-ADJ” Menu)
Menu operation n Page 42