Filter
Top Products
-
19 -
4 PAPER SETTING
This printer can feed cut sheets and paper roll. The printer function setting for cut
sheets is different from that for paper roll. See Section 6 Function Setting for details.
Setting Cut Sheets
(1) Turn the printer on.
(2) If the printer has been stored without
thermal paper, open and close the
paper cover (see Section 2 EACH
PART OF PRINTER) before setting the
cut sheet.
(3) Insert a cut sheet into the paper slot in
the printer until it stops with its printable
surface facing down.
(4) The printer detects the paper and loads
it automatically.
(5) To discharge the paper from the printer, hold down the FEED switch.
CAUTION
Take care not to get your fingers caught in the printer when loading
paper.
NOTE
- Insert the paper into the paper slot straight. If it is askew, a paper feed
error occurs.
- DO NOT block the paper outlet or hold the paper that is being loaded.
Otherwise, it may cause a paper jam.
HINT
• Marks for paper position detection are printed on the back of the
specified paper. When the printer detects the mark, it enters print-ready
mode.
• If the printer does not detect a mark, the ERROR lamp blinks. Press the
FEED switch once or turn the printer off and on again to clear the error.
Place a cut sheet with the paper
position detection mark facing up.