Filter
Top Products
- 28 -
DIP switch 3
Posi-
tion
Function Setting
bit8 Reserved 1 Fixed to 1
bit7 0 0 1 1
bit6
Print
Density
*3
0
95%
1
100%
0
105%
1
110%
0 0 0 0
bit5
0 0 1 1
0
PD160R-N
1
TC98KS-LH
0
P350
1
Reserved
bit4
1 1 1 1
0 0 1 1
bit3
Paper
Select
*1 *3
0
KT55F20
1
TF8067
0
TL69KS-HW76B
1
TF50KS-E2D
(TP-341L-1)
bit2 0 0 1 1
bit1
Paper Mode
0
Cut Paper
1
Roll Paper
0
Mark Roll
Paper
*2
1
Reserved
*1 : See Section 12 OPTIONS AND CONSUMABLE PARTS for details of papers.
*2 : For details, see DPU-S445 SERIES THERMAL PRINTER TECHNICAL REFERENCE.
*3 : If too much energy is applied to the thermal head, it would shorten its life span and cause the
paper feed problem. Set an accurate thermal paper selection and print density.
If selecting the thermal paper that is different from the one specified in the thermal paper selection
or in case of not setting the print density in 100%, verify the performance with your actual device
before printing.
DIP switch 4
Posi
-tion
Function Setting
bit8
Reserved
1 Fixed to 1
bit7
Reserved
1 Fixed to 1
bit6
Reserved
1 Fixed to 1
1 Disable
bit5
Mark Position
Correct
*1
0 Enable
bit4 0 0 1 1
bit3
Bluetooth Baud
Rate
*2
0
230400
bps
1
57600
bps
0
115200
bps
1
230400
bps
1 Disable
bit2
CTS Control
0
Enable
1 Disable
bit1
Auto Activation
by AC
*3
0
Enable
*1 : When Paper Mode of DIP switch 3 is set as Mark Roll Paper, the printer operates paper feeding to
backward approximately 5 mm just before printing process after operations such as the power on,
resetting, FEED switch or page feed. If the function sets to Enable, be sure to send printing pattern
that is longer than 5 mm. If the function sets to Enable while using the label paper, the length of label
should be 40 mm or longer.
*2 : This setting is enabled only the Bluetooth supported model. Generally, select Bluetooth baud rate
to 230400bps.
*3 : If this setting is enabled, the printer turns on automatically when the AC cable of the AC adapter
inserts to the outlet.