Filter
Top Products
-
22 -
6 FUNCTION SETTING
This printer allows you to set various function according to operating conditions or uses.
The settings are stored in the software DIP switches (NV memory) in the printer. They
can be set by using switches or by entering commands.
This manual describes how to set functions by using switches.
HINT
• See the Technical Reference for details on function setting with
commands.
Function Setting Mode
The printer must be in the function setting mode to set functions with switches.
To enter the function setting mode, do as follows:
(1) Make sure that the thermal paper is loaded in the printer and the printer is off. If the
thermal paper is not loaded, load the thermal paper as described in Section 4, Paper
Setting, and then turn the printer off.
HINT
• If an error occurs in the function setting mode, the POWER and ERROR
lamps blink 3 to 4 times and the power is turned off.
(2) Press the POWER and FEED switches at the same time. When the POWER lamp
and the ERROR lamp light, and six seconds later the POWER and ERROR lamps
start blinking, release your fingers from both of the switches.
(3) If the message shown at the following is printed, press the FEED switch.
Select Function
Setting Mode: Feed SW / HEX Dump Mode: Power SW