Filter
Top Products
Page 39 of 55
airPoint™ Nexus User Configuration Guide
intelligent wireless platform
5.3. Link Test
The Link Test tools are available from the navigation menu bar ‘Tools’ | ‘Link Test’ drop down menu.
From Link Test tools the user can test Throughput and perform Ping Test. You will need to run Radio
Transmit or Radio Receive. The client device will automatically start receiving /transmitting (provided
an airClient Nexus is used).
The user needs to specify the IP address for the test.
Note: Throughput test works only between sB Nexus Devices.
Follow the steps below to do a Ping Test:
1. Enter a valid IP address for Far-end Radio IP Address.
2. Click on the ‘Start’ button under ‘Ping’
3. The Ping result will be displayed.
4. Click on the ‘Stop’ button to stop the test.
Figure 5-7 Ping Test Result
Follow the steps below to do a Throughput Test:
1. Setup a link between two airPoint™ units.
2. Enter a valid IP address of the Far-end Radio IP Address.
3. Click on the ‘Radio Receive’ button at one end under the Throughput Test and at the other
end Click on the ‘Radio Transmit’ button.
4. The Throughput test will start and the result will be displayed.
5. Click on the ‘Stop’ button to stop the test.