Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
3-2
After connecting to the system through the console port, the login screen
displays:
Telnet Connection
Telnet operates over the IP transport protocol. In this environment, your
management station and any network device you want to manage over the
network must have a valid IP address. Valid IP addresses consist of four
numbers, 0 to 255, separated by periods. Each address consists of a
network portion and host portion. For example, the IP address assigned to
this switch, 10.1.0.1, consists of a network portion (10.1.0) and a host
portion (1).
To access the switch through a Telnet session, you must first set the IP
address for the switch, and set the default gateway if you are managing the
switch from a different IP subnet. For example,
If your corporate network is connected to another network outside your
office or to the Internet, you need to apply for a registered IP address.
However, if you are attached to an isolated network, then you can use any
IP address that matches the network segment to which you are attached.
User Access Verification
Username: admin
Password:
CLI session with the SMC6750L2 is opened.
To end the CLI session, enter [Exit].
Console#
Console(config)#interface vlan 1
Console(config-if)#ip address 10.1.0.1 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 10.1.0.254