Filter
Top Products
GVRP
AND
B
RIDGE
E
XTENSION
C
OMMANDS
3-107
Note: Set GVRP timers on all Layer 2 devices connected in the same
network to the same values. Otherwise, GVRP will not operate
successfully.
Example
Related Commands
show garp timer
show garp timer
Use this command to show the GARP timers for the selected interface.
Syntax
show garp timer [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
Shows all GARP timers.
Command Mode
Normal Exec, Privileged Exec
Example
Console(config)#interface ethernet 1/1
Console(config-if)#garp timer join 100
Console(config-if)#
Console#show garp timer ethernet 1/1
Eth 1/ 1 GARP timer status:
Join timer: 20 centiseconds
Leave timer: 60 centiseconds
Leaveall timer: 1000 centiseconds
Console#