Filter
Top Products
I
NTERFACE
C
OMMANDS
3-71
Example
The following example configures port 11 to use autonegotiation.
capabilities
Use this command to advertise the port capabilities of a given interface
during autonegotiation. Use the no form with parameters to remove an
advertised capability, or the no form without parameters to restore the
default values.
Syntax
capabilities {1000full | 100full | 100half | 10full | 10half |
flowcontrol | symmetric}
no port-capabilities [1000full | 100full | 100half | 10full |
10half | flowcontrol | symmetric]
• 1000full - Supports 1000 Mbps full-duplex operation
• 100full - Supports 100 Mbps full-duplex operation
• 100half - Supports 100 Mbps half-duplex operation
• 10full - Supports 10 Mbps full-duplex operation
• 10half - Supports 10 Mbps half-duplex operation
• flowcontrol - Supports flow control
• symmetric - Transmits and receives pause frames for flow control
(Gigabit ports only)
Default Setting
The default values for Fast Ethernet include 10half, 10full, 100half,
100full and flow control. The default values for Gigabit Ethernet
include all settings.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#