Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
3-50
ip address
Use this command to set the IP address for this device. Use the no form
to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
Default Setting
IP address: 0.0.0.0
Netmask: 255.0.0.0
Command Mode
Interface Configuration (VLAN)
Command Usage
• You must assign an IP address to this device to gain management
access over the network. You can manually configure a specific IP
address, or direct the device to obtain an address from a BOOTP or
DHCP server. Valid IP addresses consist of four numbers, 0 to 255,
ip
default-gateway
Defines the default gateway through which an
in-band management station can reach this
device
GC 3-52
show ip interface Displays the IP settings for this device PE 3-53
show ip redirects Displays the default gateway configured for
this device
PE 3-54
ping Sends ICMP echo request packets to another
node on the network
NE,
PE
3-54
Command Function Mode Page