Filter
Top Products
SNMP C
OMMANDS
3-47
Example
Related Commands
snmp-server enable traps
snmp-server enable traps
Use this command to enable this device to send Simple Network
Management Protocol traps or informs (SNMP notifications). Use the no
form to disable SNMP notifications.
Syntax
snmp-server enable traps [authentication | link-up-down]
no snmp-server enable traps [authentication |
link-up-down]
• authentication - Keyword to issue authentication failure traps.
• link-up-down - Keyword to issue link-up or link-down traps.
Note: The link-up-down trap can only be enabled/disabled via the
command line interface.
Default Setting
Issue all traps.
Command Mode
Global Configuration
Command Usage
If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to
configure this device to send SNMP notifications, you must enter at
least one snmp-server enable traps command. If you enter the
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#