Filter
Top Products
6 Precautions
Please read throughly this Safety
Regulations and Installation Manual
contained in the CD-ROM for safe
installation.
On safety
• Avoid using an extension cord with a low
voltage limited since it may cause the
short-circuit and physical incidents.
• To carry the projector, be sure to use the
carrying handle. Do not hold other parts of
the projector, especially the lens, nor catch
your finger between the handle, floor, and
the projector.
• Do not catch your finger between the unit
and surface of the floor when moving the
projector installed on the floor.
• Be careful not to catch your finger in the
cooling fan.
• Do not carry the projector with the cabinet
on and with its cover open.
On installation
• When the projector is mounted on the
ceiling, the Sony PSS-620 Projector
Suspension Support must be used for
installation.
• Allow adequate air circulation to prevent
internal heat build-up. Do not place the
unit on surfaces (rugs, blankets, etc.) or
near materials (curtains, draperies) that
may block the ventilation holes. Leave
space of more than 50 cm (19
3
/4 inches)
between the wall and the projector. Be
aware that room heat rises to the ceiling;
check that the temperature near the
installation location is not excessive.
• Install the projector on the floor or ceiling.
Any other installation causes a
mulfunction such as color irregularity or
shortening lamp life.
• Do not install the unit in a location near
heat sources such as radiators or air ducts,
or in a place subject to direct sunlight,
excessive dust or humidity, mechanical
vibration or shock.
• To avoid moisture condensation, do not
install the unit in a location where the
temperature may rise rapidly.
• Be sure to secure the cabinet cover firmly
when installing to the ceiling firmly.
For dealers