Support User Manuals

Sony MP595 Modem User Manual

Open as PDF

of 88

Configuring the MP Modem to Report GPS and I/O

Data

Rev 1.5 Jul.08 59

Digital I/O setup

TheDigitalInput/Outputwindow(Tools > Options > MP > 

Input/Output > Digital I/O)isusedtoconfiguredevicesonthetwo

digitalI/Oandtwodigitalinputports.Eachtabcorrespondsto

apin:

Toconfigureadigitalsensororgauge,selectthetabthatcorre‐

spondstothepinyouareusingandcompletethefieldsas

follows:

• Label:Provideadescriptionofthesensororgauge,upto

20charactersinlength.

• Type:SelectInput,Output,orNot used.(Outputisnot

availableontabs3and4.)

• Logiclowname:Describethestateofthedeviceatlogic

levellow,upto20

charactersinlength.(Forexample,ifa

switchintheoffpositionleadstoalogiclow,youcould

choosetolabelit

Switched Off.)

• Logichighname:Describethestateofthedeviceatlogic

levelhigh,upto20

charactersinlength(suchasSwitched

On

).

• Alarmlogiclevel:AssignanactionassociatedwiththeI/O

port:

· high:Anotificationissent,andtheeventislogged,ifthe

statechangesfromalogiclowtoalogichigh.

· low:Anotificationissent,andtheeventislogged,ifthe

statechangesfromalogichightoalogiclow.

· logonly:Nonotificationissent,butanychangeinlogic

levelislogged.

Thenameandlocationofthelogfileisspecifiedinthe

Input/Outputwindow(

Tools > Options > MP > Input/Output).

Bydefault,thelogfileislocatedintheprogramfolderor

userfolderandiscalledMpIoLog.txt.

• Currentvalue:Showsthecurrentvalueoftheport.

Digital Tab Connector Pin

I/O 1 Input or output on pin 3

I/O 2 Input or output on pin 11

Input 3 Input on pin 4

Input 4 Input on pin 12

previous next