Sony VPL-HS20 Projector User Manual


 
Step 3: Adjusting the Picture Size and Position
Connections and
Preparations
GB
20
5
Adjust the focus using the
FOCUS +/– button, and adjust
the picture size using the
ZOOM +/– button.
6
Adjust the position of the
picture to fit the screen using
the adjuster.
Adjusting the picture position using
the adjuster
Lift the projector while pressing the adjuster
adjustment button, and release the button.
Holding the adjuster adjustment button pressed,
move the projector, then release the button at the
locked position.
To adjust vertically
Lift the projector while pressing the adjuster
adjustment button, then lock the adjuster by releasing
the button at the proper point.
To adjust horizontally
Adjust by turning the round pads of the adjuster to the
right or left.
7
Adjust the picture size and
position.
If “Side Shot” or “V Keystone” are adjusted
manually (value adjustment), the built-in test
pattern is projected on the screen. If you want to
make adjustments using the current input signal,
set “Test Pattern” in the INSTALL SETTING
menu to “Off.” (1 page 35)
When projecting using “Side Shot”
adjustment only
When projecting using “Side Shot” adjustment only,
you can adjust to correct horizontal trapezoidal
distortion using the “Side Shot” function to the
maximum.
1 Set “V Keystone” in the INSTALL SETTING
menu to “Manual", press ENTER, then M,
m or RESET to set the level to “0.” The
adjuster is reset.
Note
If “V Keystone” is set to “Auto,” the correction capacity of “Side
Shot” is reduced.
2 Position the projector so that the picture
overlaps on the screen as shown below.
Check that both vertical sides of the picture are
parallel to the both vertical sides of the screen.
If the picture does not overlaps on the screen as
shown above, confirm and adjust the installation
position of the projector and screen referring to
FOCUS +/– button
ZOOM+/– button
Adjuster
Adjuster
adjustment
button
To heighten
To lower
Screen
Projected picture
Adjust so that the bottom side
of the picture is parallel to the
bottom side of the screen.