Filter
Top Products
36
GB
Symptom
An image is printed
with borders even if
I select borderless
print option.
An image is not
printed in correct
colors.
Preview image does
not reflect the print
settings in the
“Graphics” tab of
the “Sony DPP-
FP30 Properties”
dialog box.
Print quantity
specified in the
“Paper/Output”
tab of the “Sony
DPP-FP30
Properties” dialog
box does not take
effect.
Check
• Are you using an
application software
other than
PictureGear Studio?
• Is “Exif Print” checked
in the “Graphics” tab
of the “Sony DPP-
FP30 Properties”
dialog box?
•
Is “ICM” selected in
the “Graphics” tab of
the “Sony DPP-FP30
Properties” dialog box?
• Are you using
PictureGear Studio?
Cause/Solutions
c
When using an application other than the
PictureGear Studio, an image might be printed
with borders even if you select borderless
print. If this occurs, do either of the following
to print an image without borders:
–When you can set print range with an
application, set an image to be printed fully
in the print range even if it is printed over
the range.
– Set a larger value in the “Enlarge/Reduce”
text box in the “Paper/Output” tab of the
“Sony DPP-FP30 Properties” dialog box.
(.page 28)
– If borders remain on the right and bottom
sides of a printed image even after you set a
larger value, check “Upper left reference”.
c The Exif Print setting in the “Color
reproduction/Picture quality” section
supports the PictureGear Studio only. To
print from other application, uncheck “Exif
Print”.
cThe ICM setting may be valid only when
you are using an ICM-compliant
application. Check to see if the application
software you are using supports ICM.
cThe print settings adjusts the printer itself
and cannot influence the preview image.
c
Set the print quantity in the “Print” dialog
box of the PictureGear Studio. The print
quantity setting in the “Paper/Output” tab
of the printer driver does not take effect.
c
Depending on the application software you
use, the print quantity setting of the
application software may have priority over
the setting specified in the printer driver
dialog box.