Filter
Top Products
18 Connecting the Projector
To connect a Macintosh computer equipped
with video output connector of a type having
two rows of pins, use a commercially available
plug adaptor.
This section describes how to connect the
projector to a VCR.
For more information, refer to the
instruction manuals of the equipment you
are connecting.
To connect to a video or S video
output connector
Ex. VPL-CS7
1Stereo audio connecting cable (not supplied)
(Use a no-resistance cable)
2Video cable (not supplied) or
3S-Video cable (not supplied)
To connect to a video GBR/
component output connector
Ex. VPL-ES2
1SMF-402 Signal Cable (not supplied)
HD D-sub 15-pin (male) y 3 × phono plug
or
2Component video (3 × phono plug
y 3 ×
phono plug (not supplied) (Use a 75 Ω
coaxial cable) (VPL-ES2 only))
3Stereo audio connecting cable (not supplied)
(Use a no-resistance cable)
• Set the aspect ratio using “Wide Mode” in
the INPUT SETTING menu according to the
input signal.
• When you connect the INPUT A connector
on the unit to a video GBR output connector,
select “Video GBR,” or when you connect it
to a component output connector, select
“component” with the “Input-A Signal Sel.”
setting in the SET SETTING menu. The
input selection must be performed before
inputting the signal.
• Use the composite sync signal when you
input the external sync signal from video
GBR/component equipment.
Note
Connecting with a VCR
AUDIO
AUDIO
INPUT A
S VIDEO
VIDEO
MONITOR OUT
VCR
to S video
output
Left side
to audio
output
to video
output
2
1
3
Notes
AUDIO
YPB/CBPR/CR
AUDIO
INPUT A
S VIDEO
VIDEO
Left side
to
audio
output
15k RGB/Component equipment
to RGB/
component
output
2
3
1