Filter
Top Products
19Projecting
Projecting the Picture
This section describes how to connect the
projector to a monitor equipment.
For more information, refer to the
instruction manuals of the equipment you
are connecting.
* This projector is not guaranteed for
connecting more than 2 monitors in loop-
through connection.
Projecting
1 Plug the AC power cord into a wall
outlet, then connect all equipment.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
2 Press the I / 1 key.
The ON/STANDBY indicator lights in
green and the Intelligent Auto-setup
starts. The lens protector opens, and the
powered tilt adjuster rises and stops at
the previously adjusted position.
3 Turn on the equipment connected to
the projector.
Connecting with a Monitor
Equipment (VPL-CS7 only)
MONITOR OUT
AUDIO
INPUT A
S VIDEO
VIDEO
Left side
Monitor cable (not
supplied)
HD D-sub 15-pin (male)
↔ HD D-sub 15-pin
(male)
to monitor
input
Monitor equipment
INPUT MENU
PUSH
ENTER
TILT
8
ON/STANDBY indicators
Remote control
detector