Filter
Top Products
F:\Nouhin_NAGANO_E\0403N_VPL-
CX63_OM_CDROM\0403N_2684389111VPLCX63GB_OM\02C01.fm
masterpage: Left
10
Location and Function of Controls
VPL-CX63/CX61
2-684-389-11 (1)
g Speaker
h Rear remote control detector
i Ventilation holes (intake)
j Adjusters (hind pad)
Turn the appropriate adjuster to the right
or left for minor tilt adjustment of the
projected picture.
k Ventilation holes (intake)/Lamp
cover
l Ventilation holes (intake)/Air
filter cover
• Do not place anything near the
ventilation holes as this may cause
internal heat build-up.
• Do not place your hand near the
ventilation holes as this may cause
injury.
• To maintain optimal performance, clean
the air filter every 1000 hours.
For details, see “Cleaning the Air
Filter” on page 38.
m Security lock
Connects to an optional security cable
(from Kensington).
Web page address:
http://www.kensington.com/
n Connector Panel
For details, see “Connector Panel” on
page 11.
a ?/1 (On/Standby) key
Turns on the projector when it is in
standby mode. When you push this key,
the ON/STANDBY indicator around the
?/1 key flashes in green until the
projector is ready to operate.
b ON/STANDBY indicator (located
around the
?/1 key)
Lights up or flashes under the following
conditions:
– Lights in red when the AC power cord
is plugged into a wall outlet. Once the
projector is in standby mode, you can
turn it on with the ?/1 key.
– Lights in green when the projector is
turned on, and when it is ready to
operate.
– Flashes in green from the projector is
turned on until the projector is ready to
operate. Also, flashes in green while
the cooling fan is running after the
power is turned off with the ?/1 key.
Notes
Control Panel
–
+
–
+
VPL-CX63
6
7
8
9