SOYO SY-6BA+ III Computer Hardware User Manual


 
Hardware Setup SY-6BA+ III
21
Step 13. 5V Stand-by indicator LED (LED 1)
This LED is lit whenever the 5V Standby voltage coming from the
ATX powersupply is available. If you have connected your ATX
powersupply to the mains, LED 1 should be lit.
Step 14. External Suspend Button (JP1)
Some cases come with a suspend button, insert the plug into JP1. In
addition to this button, the system can also enter the suspend mode
through your OS.
Note: Suspend mode only functions if your Power Management mode is APM.
Make sure that the BIOS setting for Power Management is APM. Windows 98
can be installed with ACPI Power Management (default is APM), in this case
suspend mode will not function either.
Step 15. CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory
by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.
Then restore JP5 to the initial 1-2 jumper setting in order to recover
and retain the default settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Clear CMOS Data Retain CMOS Data
JP5
Setting
Short pin 2-3 for
at least 5 seconds
to clear the CMOS
Short pin 1-2
to retain new
settings
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
3
2
1
3
2
1